How to Connect a Wall Light

Wall lamp allows you to create a romantic and subdued lighting in the room. If you are familiar with the electricity, you can connect your own wall lamp by place not only close to the outlet, as often happens, and in accordance with your idea of comfort.

For wiring to be seen, during the repair of the walls do not forget to lay all the cables in the walls.  If the walls are covered with plaster, before all the work, wall using the gun and run wires, then cover them with a mixture of cement or plaster. It is possible to bring the wire in the plinth and pull them to the box for special slots or be integrated in the screed before laying self-leveling floor. And if you choose lights for outer wall, you can get the PIR stainless steel wall lights.

After finishing the walls begin installation of lighting. Turn off the power at the mains. On the wall mark the install location, enclosing the luminaire body. Note the location for holes. It is convenient to do was knit to the lamp with the back of the pieces of plasticine or double-sided tape.

Drill the holes using a drill with a large drill. The resulting hole, insert the plug and screw the lamp cover back with screws. Connect the lamp to the terminal wire supply, isolate and place in the box. Note that the terminals must be connected in the correct sequence: wire "grounded" to the earth terminal in the junction box, and then insulated wires - to the pads of the lamp. Screw the lid box, assemble the remaining elements of the fixture, screw in the bulb. Installing the lamp is completed. Recheck the mounting reliability and plug it in. BTW, you can select the wall lights at Banggood. Besides, you can easily get other lighting (e.g. solar pool fence cap lights) there with high quality and reasonable prices.

If you need to carry out installation of wall lamp in the bathroom or the bathroom, read the appropriate SNIP. Buy only water proof 12-volt appliances. Transformer for fixtures located outside the bathroom. In any case, switches and lights themselves must be placed no closer than 60 cm from the bath or sink.